CR-43 Nissan Navara NP300 Air Bag Coil Replacement (Coil Delete) Kit

This is our AAA Coil Replacement kit – also referred to as a coil delete kit. Remove the coil springs and fit these bags.

Advantage #1 – The bags can carry significantly more weight than coils and not sag. Just keep adding air until the ride height is right no matter how heavy the load is. These are a truck bag so well and truly capable of the heaviest loads.

Advantage #2 – They are softer than coils. Only run the air pressure needed to run at your given height. Any softer and it will sit lower. Any harder and it will sit higher so it has to be the softest achievable for your given height.

When people put air bags inserts inside coils they also find they have to get a heavier coil and naturally when they are not loaded they have to put up with a stiff coil. And worse – they learn they are still not heavier enough. No more of those problems with the AAA Coil Delete Kit.

The rubber in these bags is heavier than the rubber in the sidewalls of your tyres. Unlike the tyres the bags are not on the ground so much less likely to get damaged. In fact you are more likely to break a coil spring than harm a bag. But in that most unlikely event it’s good to know you can repair a puncture in a bag with a tyre repair string, same as you would fix a hole in a tyre.

As these replace the coil spring using the original coil spring mounts there is no additional load on any other sections of your chassis so you can rule out the possibility of harming the chassis.

We sell this kit in a few different levels (pun intended) :

• Basic manual kit – comes with bags, mounts, air lines and valves. Manually pump each bag to the desired height.
• With In Cab = have a gauge and up/down buttons to raise or lower the bags independantly from inside the car
  • Without compressor – if you already have a compressor fitted then use that.
  • With AAA Compressor
  • Optional extra – Remote control. Plug and play addition to the AAA wiring harness
• With Auto Ride Height Control – mechanical height sensor kit maintains ride height – van on or van off – always the same height

GVM options –

Our Engineer is working on GVM upgrades as we speak. We have alsready had all the testing done including brake tests and swerve tests. What we do know having achieved this with other vehicles the kit will need to have the auto ride height control using all our tested AAA components and set up to our design specifications – means you cant chop out parts or change things and expect to still get a GVM.

You can start with the manual kit and add the in cab or auto ride height kits later when you like.